Audio & Design SyncroGenius HD-Pro Reference Generator W/Optional Broadcast Pack

Description

UP FOR YOUR CONSIDERATION
1-AUDIO & DESIGN SYNCROGENIUS HD-PRO
REFERENCE GENERATOR
HD, SDI, AES, Word-Clock, Genlock
FULLY TESTED AND READY TO BE PUT TO WORK.
LIST PRICE OVER ,000.00 NOT COUNTING THE POWER SUPPLY UPGRADE
FOR REDUNDANCY 0.00
AES-3 GRADE 1 REFERENCE UPGRADE 0.00
NOT
SURE IF IT HAD THE
AES-3 GRADE 1 REFERENCE UPGRADE
I contacted Audio & Design and here was there response
Hi Wade,
I can confirm both these units were sold to our US agent as HD Pro units with the Additional PSU and the AES Grade 1 Crystal Upgrade.
Your unit should have 2 mains inlets on the rear panel and 2 power leds for PSU1 and PSU2 on the front panel.
S/N 1218 – sold 8/12/2011 and S/N 1348 sold 25/8/2016.
Hope this helps,
Kind regards,
Ian
EACH IS IN GREAT USED CONDITION AND WILL BE PACKED TO MAKE IT TO YOU IN THE SAME CLEAN CONDITION.
FROM AUDIO & DESIGN
SYNCROGENIUS HD-PRO
Designed to solve all the synchronisation issues found in video and audio production, this range will genlock to HD tri-level sync and SD bi-level sync video signals, AES and word-clock digital audio reference signals, LTC from video or audio time code or a GPS reference clock. Multiple outputs for HD video, SD video, AES audio and word clock are generated internally and electronically buffered. Options are offered separately to enhance performance to a AES-3 Grade 1 reference, and to provide redundancy with dual power supplies.
Syn
croGen
ius HD-Video, AES and Word
The input reference may be selected, video formats are auto detected. All HD frame rates may be selected in progressive scan and interlaced 1080 or 720 modes, when internal mode is selected. The relevant SD frame is automatically generated to feed the SD outputs. HD and SD outputs can reproduce any video input reference or be set to the internal master house sync. Simultaneous AES and word clock outputs are genlocked and phase coherent to the input reference. Pull up/down sample rates are adjustable to suit all film, video and audio applications. True DDS direct digital synthesis leads to ultra-low jitter performance and ultra high frequency stability.
The front panel has status indicators for the two power supplies (one as standard), and six separate control areas. All controls are momentary push buttons, which toggle through available settings, indicated by LEDs. The sync source area allows selection of internal, video and clock sources. The video reference may be SD or HD. The clock reference may be AES, word clock, GPS or LTC. The 'Tri-Level Sync output' section offers the choice of 1080p, 1080i, 720p modes, and eight different frame rates. Two LEDs indicate input or internal source. Two further areas independently set video SPG and digital reference outputs. The lock control area has a recessed 'lockout' switch to defeat the controls on the front panel.
The rear panel has an IEC power inlet with adjacent switch. External reference inputs are a pair of RCA(phono) connectors for LTC input and loop-out, a female XLR connector for AES audio input, four BNC connectors provide word-clock, GPS and HD/SD inputs, HD/SD loop out. Six BNC connectors offer three HD and three SD video outlets. A further six provide four 1x, one 2x and one 4x word clock outputs. Four male XLR connectors are used for the AES outputs. A 9-pin D-sub connector is used for a general purpose interface providing PSU output or lost-lock status; contacts close to signal a fail condition.
Operating Modes
Video input modes
1080p:
60, 59.94, 50, 30, 29.97, 25, 24, 23.98Hz.
1080i:
60, 59.94, 50Hz.
720i:
60, 59.94, 50Hz.
Video output modes
HD:
As input modes above.
SD:
525/30Hz, 29.97Hz NTSC, 25Hz PAL, Film 24Hz (slow PAL), Film 23.96Hz (slow PAL).
Clock reference modes
AES input:
32kHz to 192kHz.
Word clock input:
32kHz to 192kHz, +/-4% window.
GPS input:
1, 2, 5, 10MHz.
LTC input:
24, 25, 29.97, 30 frames +/-4% window, auto detect.
Word clock outputs:
192, 176.4, 96, 88.2, 48, 44.1kHz.
AES outputs:
192, 176.4, 96, 88.2, 48, 44.1kHz
Video outputs: 1V pp, 75ohms. HD tri-level, SD bi-level. Word clock outputs: 2.7V pp, 75ohms, less than 40ps RMS sample-to-sample jitter, wideband. Word clock pull-up/pull-down +/-4.16% and/or +/-0.1%. AES audio outputs: 3.0V, 110ohms, AES-3 black digits, less than 40ps sample-to-sample jitter, wideband. Pull-up / pull-down +/-4.16% and/ or +/-0.1%. Loop-through outputs: High impedance, video and LTC. Power source: 90-260V AC, 50/60Hz. Dimensions: 1U rack mounting, 229mm deep. Weight: 1.9kg.
Included accessories: IEC power cable, user manual, 75 ohm BNC terminator for video loop out.
Optional accessories: Redundant power supply and AES-3 Grade 1 reference upgrade. See below.
SyncroGenius HD-Pro-
Genlock or Video, AES and Word Clock
The HD Pro version has all the features of the
SyncroGenius HD
, with the following additions. All video and clock outputs may be genlocked from any selected video or clock reference input. The genlocked outputs are locked in frequency and phase to the reference input. All SD and HD frame rates are independently selectable and are available as separate outputs. There is one extra control area on the front panel. The 'Memory' section allows up to three individual input/output configurations to be saved and recalled locally or by remote control; the general purpose interface has additional opto-isolated inputs and tally outputs for this.
The remaining specifications and accessories are as for the
SyncroGenius HD
.
AES-3 Grade 1 Reference Upgrade
INSTALLED
This uses a crystal in an oven to maintain long term accuracy.
(better than 0.7ppm over 12months)
This option must be factory-fitted, so should be specified at the time of order. Alternatively the SyncroGenius may be returned to the factory for fitting. Return carriage charges will apply.
Extra Power Supply - Redundancy
INSTALLED
A module which fits inside the standard chassis. This option must be factory-fitted, so should be specified at the time of order. Alternatively the SyncroGenius may be returned to the factory for fitting. Return carriage charges will apply.
SyncroGenius.
Specification.
The SyncroGenius Studio Clock has the following:
Operation
Genlock all video and clock outputs from any selected video or clock
reference input. Internal generation for all HD & SD video and clock outputs.
*Genlock outputs are frequency and phase locked to reference input where permitted.
Optional Broadcast Pack can be fitted for AES-3 Grade 1 reference performance with dual mains and power supplies.
Inputs
Selectable from video Ref: 1080p – 60Hz, 59.94Hz, 50Hz, 30Hz, 29.97Hz, 25Hz, 24Hz, 23.98
Hz. 1080i/psf – 60/30Hz, 59.94/29.97Hz, 50/25Hz. 48/24Hz, 47.96/23.98Hz. 720i – 60Hz,
59.94Hz, 50Hz.
Selectable from Clock Ref: AES – 44.1KHz to 192KHz. Word Clock – 44.1KHz to 192KHz.
+/-4% window. GPS – 0.5-5vpp 75R – 1MHz, 2MHz, 5MHz,10MHz. LTC – Linear time code
auto detect from 24, 25, 29.97 & 30 frames. +/-4% window.
Outputs
VIDEO: HD – 3x BNC electronically buffered DA, selectable HD Tri-level 1vpp into 75R.
1080p – 60Hz, 59.94Hz, 50Hz, 30Hz, 29.97Hz, 25Hz, 24Hz, 23.98Hz. 1080i/psf – 60/30Hz,
59.94/29.97Hz, 50/25Hz. 48/24Hz, 47.96/23.98Hz. 720p – 60Hz, 59.94Hz, 50Hz, 30Hz,
29.97Hz, 25Hz, 24Hz, 23.98Hz.
SD – 3x BNC electronically buffered DA, selectable SD Bi-level 1vpp into75R – 525/30Hz,
29.97Hz NTSC 25Hz PAL, Film/24Hz (slow PAL), Film/23.98Hz (slow NTSC).
WORD CLOCK: 4x BNC electronically buffered DA, 2.7vpp into 75R – 192KHz, 176.4KHz,
96KHz, 88.2KHz, 48KHz, 44.1KHz, < 40ps rms sample-to-sample jitter – wide band.
Pullup/pulldown +4.16%/-4% & or +/-0.1%.
1x BNC electronically buffered, 2.7vpp into 75R – 2x Word Clock < 40ps rms sample to
sample jitter – wide band.
1x BNC electronically buffered, 2.7vpp into 75R – 4x Word Clock < 40ps rms sample to
sample jitter – wide band.
AES-3: 4x XLR electronically buffered DA, 3.0v into110R AES-3 black digits – 192KHz,
176.4KHz, 96KHz, 88.2KHz, 48KHz, 44.1KHz, < 40ps rms sample-to-sample jitter – wide
band. Pullup/pulldown +4.16%/-4% & or +/-0.1%.
Loop thru: HD/SD Video (termination supplied), & LTC (RCA) Hi-Z.
GPIO: 1x 9way D
1x 9way D type: PSU & Genlock output status via closing contacts if failed.
Up to 3 different front panel function settings selectable via closing contacts.
Front Panel
3 recallable memory settings.
Front panel tamper-proof recessed switch.
Power
90 – 260 volts ~ 50/60Hz 20watts – Fused 1A delay type 20x5mm ceramic.
(Optional Dual mains and power supplies when Broadcast Pack fitted).
Size
482.60mm (19″) wide x 44.45mm (1U) high x 229mm deep.
Weight
1.95Kg (net)
Please checkout my other listings for more Professional
Audio, Video & Stage Lighting Equipment From Around Central Florida.
Thanks For Looking!
Track Page Views With
Auctiva's FREE Counter